Dell C9000 Series Reference Manual page 695

slot/port
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information To view the show output for multiple ports of a specified slot at a time, you can specify any
random port number or a range of ports, or a combination of both.
To specify a port range, you can enter a hyphenated range of one or more port range values
separated with commas; for example, show interfaces tengigabitethernet 10/0-4,7
pfc statistics. To enter any random number of ports, you can enter a comma-separated
string of port numbers, for example show interfaces tengigabitethernet 10/0,9 pfc
statistics
Example
Dell (conf-if-te-0/1)#show int te 0/1 pfc statistics
(Summary)
Interface TenGigabitEthernet 0/1
Priority
--------------------------------------------------------------------
0
1
2
3
4
5
6
7
Example (port
Dell#show interfaces tengigabitethernet 10/0-1 pfc statistics
range)
Interface TenGigabitEthernet 10/0
Interface
--------------------------------------------------------------------------
Te 10/0
Te 10/0
Enter the slot/port number. Enter the subport number if a 40G port is
fanned-out into 10G ports.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Rx XOFF Frames
0
0
0
0
0
0
0
0
Priority Rx XOFF Frames
P0 0
P1 0
Rx Total Frames Tx Total Frames
0
0
0
0
0
0
0
0
Rx Total Frames
0
0
Data Center Bridging (DCB)
0
0
0
0
0
0
0
0
Tx Total Frames
0
0
695