Cam-Optimization - Dell C9000 Series Reference Manual

cam-optimization

Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
C9000 Series
Syntax
cam-optimization [qos]
Parameters
qos
Defaults Disabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.8.1.0
Usage Information When you enable this command, if a Policy Map containing classification rules (ACL
and/or dscp/ ip-precedence rules) is applied to more than one physical interface on the
same port pipe, only a single copy of the policy is written (only one FP entry is used).
Use this command in Configuration Terminal Batch mode to enable the settings in a
dual-homing setup.
Optimize CAM usage for QoS.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: An ACL itself may still require more that a single FP entry, regardless of the
number of interfaces. For more information, refer to the "IP Access Control Lists",
"Prefix Lists", and "Route-map" sections in the Dell Networking OS Configuration
Guide.
Content Addressable Memory (CAM) 650