Dcbx Version - Dell C9000 Series Reference Manual

dcbx version

Configure the DCBX version used on the interface.
C9000 Series
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the no dcbx version command.
Parameters
auto | cee | cin |
ieee-v2.5
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9 (0.0)
9.7(0.1)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX
version received from a peer.
• cee: configures the port to use CDD (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
• ieee-v2: configures the port to use IEEE 802.1az (Draft
2.5).
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB) 710