Dell C9000 Series Reference Manual page 427

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

max-suppress-

route-map map-

Command Modes

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information If you enter the bgp dampening command, the default values for half-life, reuse,

suppress, and max-suppress-time are applied. The parameters are position-

dependent; therefore, if you configure one parameter, configure the parameters in the

order they appear in the CLI.

show ip bgp dampened-paths

again advertised (or no longer suppressed). The range is from 1

to 20000. The default is 750.

(OPTIONAL) Enter a number as the suppress value, which is

compared to the flapping route's Penalty value. If the Penalty

value is greater than the suppress value, the flapping route is no

longer advertised (that is, it is suppressed). The range is from 1 to

20000. The default is 2000.

(OPTIONAL) Enter the maximum number of minutes a route can

be suppressed. The default is four times the half-life value. The

range is from 1 to 255. The default is 60 minutes.

(OPTIONAL) Enter the keyword route-map then the name of a

configured route map.

Only match commands in the configured route map are

ROUTER BGP-address-family

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

— views the BGP paths.

Border Gateway Protocol

Chapters

Table of Contents