Boot System - Dell C9000 Series Reference Manual

boot system

Specify the location where the Dell Networking OS image used to boot the system is stored.
C9000 Series
Syntax
boot system [gateway ip address | [rpm0 {default | primary |
secondary [ftp: | system:{A:| B:} | tftp:] }] [rpm1 {default |
primary | secondary [ftp: |system:{A:|B:} | tftp:]}]
Parameters
gateway
ip-address
rpm0
rpm1
default
primary
secondary
ftp:
system A: | B:
tftp:
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Enter the IP address of the default next-hop gateway for the
management subnet.
Enter an IP address in dotted decimal format.
Enter the keyword rpm0 to specify the route processor module
0.
Enter the keyword rpm1 to specify the route processor module
1.
Enter the keyword default to use the default Dell Networking
OS image.
Enter the keyword primary to use the primary Dell Networking
OS image.
Enter the keyword secondary to use the secondary Dell
Networking OS image.
Enter the keyword FTP: to retrieve the image from an FTP
server: ftp://userid:password @host-ip/filepath.
Enter A: or B: to boot one of the flash system partitions.
Enter the keyword TFTP: to retrieve the image from a TFTP
server: tftp://host-ip/filepath.
File Management 201