Ipv6 Ospf Bfd All-Neighbors - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

show bfd neighbors

specified interface.

ipv6 ospf bfd all-neighbors

Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session

C9000 Series

ipv6 ospf bfd all-neighbors [disable | [interval interval min_rx

min_rx multiplier value role {active | passive}]]

To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6 ospf

bfd all-neighbors disable command in interface mode..

milliseconds

milliseconds

multiplier value

role [active |

Introduced on the Z9500.

Introduced on Z9000, S4810, and S4820T.

Introduced on the E-Series ExaScale.

Introduced on the C-Series.

Introduced on the E-Series.

– displays the BFD neighbor information on all interfaces or a

(OPTIONAL) Enter the keyword disable to disable BFD on this

(OPTIONAL) Enter the keyword interval to specify non-

default BFD session parameters beginning with the transmission

interval. The range is from 50 to 1000. The default is 200.

Enter the keywords min_rx to specify the minimum rate at

which the local system receives control packets from the

remote system. The range is from 50 to 1000. The default is

Enter the keyword multiplier to specify the number of

packets that must be missed in order to declare a session down.

The range is from 3 to 50. The default is 3.

Enter the role that the local system assumes:

Active — The active system initiates the BFD session.

Both systems can be active for the same session.

Bidirectional Forwarding Detection (BFD)

Table of Contents