Quick Start Guide (Installation Notes) - ABB ArcSwitch Manual

16 A R C S W I T C H ® M A N U A L
—

Quick start guide (installation notes)

—
Rules for the correct installation of the
06
ArcSwitch panel unit™
ArcSwitch basic
connection drawing
In order to guarantee the correct and reliable
operation of the ArcSwitch Panel unit™, the
installation should be carried out by a qualified
electrician and they should follow the
instructions supplied in this document.
Safety requirements
ATTENTION:
Read the manual carefully before starting to use.
and Keep the instructions for future reference.
Do not open the device, touching any internal
components can cause electric shock. Contact
with a voltage over 35 Volts can be fatal. To
reduce the risk of electric shock, do not dismantle
the back of the device for any reason there is no
service usable parts inside. Moreover, opening
will void the warranty.
Before connecting the device to the power
supply, make sure that all the connections are
correct. Always disconnect the unit from the
supply before any cabling modification.
CB opening circuit
DC positive
DC negative
Ground / earth
—
06
Protection trip
Opening button
Opening coil
Failure to comply with these instructions can
cause damages, fires or electric shock, and
possible serious injuries or death!
Power supply:
The ArcSwitch Panel Unit™. Can be supplied by 0
up to 230 V AC / 220 V DC, before using it, make
sure the power cable is not damaged, knotted, or
pinched. Do not tamper with the power cable.
Never disconnect the unit by pulling the cable,
avoid touching the pins. Do not carry out any
connecting / disconnecting with wet hands. To
disconnect the device, do not use objects such as
levers. Immediately disconnect the device if you
smell burning or see any smoke: contact technical
service.
USE SHOULD BE RESERVED TO QUALIFIED
PERSONNEL ONLY:
The purchased goods are a sophisticated
electronic device that is totally unsuitable to be
installed by non - qualified personnel. Any work
must be carried out by a specialist Engineer or
Qualified Electrician.
CB closing circuit
Closing button
Closing coil
Any work on the equipment must be
entrusted to a qualified Electrician.
ArcSwitch
panel meter