Sharp AR-SS2 Service Manual page 12

AR-SS2
2) Adjust engagement of the lead cam drive gear (1) so that the
upper blade tips of the lead cams on the front and the rear sides
are as shown in the figure below.
3) Attach the E-ring.
Note: When assembling the flag (1) for the lead cam home position
sensor, fit the teeth tips (2) of the lead cam with the phase of
the flag (1) as shown below.
2
E. Guide bar motor (M3) removal
1) Lift the bin unit to the top for easiness of work.
2) Remove the screw (1) and remove the bin lower unit cover (2).
3) Remove the connector (3) and two screws (4), and then remove
the guide bar motor (5).
1
3
4
1
2
5
3. Transport duide
A. Transport guide unit removal
1) Remove the front cover.
2) Remove the screw (2) and the latch lever holder (1).
2
3) Remove the latch lever (3) and the latch (4).
4) Remove the screw (5), and remove the transport guide unit (6).
3
B. Transport motor (M2) removal
1) Remove the rear cover.
2) Remove the connector (1) and two screws (2), and then remove
the transport motor (3).
2
4 – 4
1
4
6
5
3
1