Sharp AR-SS2 Service Manual page 5

4. Fix the sorter to the rail unit.
[Note] When lifting the sorter, hold the sorter as shown in the figure
so as not to make contact with the sorter bin.
Insert the positioning screws on the lower side of the sorter into the
rail unit positioning holes, and slide the sorter inward.
Positioning holes
At that time, position the wiring of the sorter as shown in the figure.
Fix the sorter unit with the sorter fixing screws on the front and the
rear sides of the rail unit.
5. Install the lock plate and check that the staple sorter
1) Fix the lock plate with two mounting kit fixing screws (M4 x 18 S
2) Lock the staple sorter to the copier body, and check the clearance
3) Loosen two mounting kit fixing screws so that the sorter lock pawl
Positioning holes
2 – 3
Sorter fixing screw
is installed.
tight) with the sorter mounting plate lowered as shown in the
figure.
Lock plate
Mounting kit fixing screw
between the sorter lock pawl and the lock plate. (Refer to Fig. 1)
and the lock plate are in contact horizontally. Adjust the lock plate
height. One scale corresponds to about 2mm. (Refer to Fig. 2)
At that time, check that the paper exit cabinet of the copier can be
opened and closed.
Sorter lock pawl
Lock plate
Contact
Clearance
[Fig. 1]
AR-SS2
Sorter fixing screw
Mounting kit fixing screw
[Fig. 2]