Sharp AR-SS2 Service Manual page 6

AR-SS2
6. Connect the sorter connector.
Remove the sorter connector cover attached to the rear cabinet of the
copier.
Connect the sorter connector to the connector of the copier and
tighten the screw to fix the connector.
Connector of the copier
7. Attach the staple position label.
•
Attach the staple position label as shown below.
Staple position label A (for the copier)
Staple position label D (for the RADF)
Sorter connector cover
Sorter connector
Screw
2 – 4
Insert the power plug of the copier into the power
outlet, turn on the power switch, and follow the
procedures below.
8. Set the mode.
•
Set the mode with the key operation of the copier.
2
P C
Clear
Select the corresponding
number with the 10-key.
9. Check the operation of the staple sorter.
Align the paper to be stapled.
•
The max. stapling capacity is 30 sheets. If the max. capacity is
exceeded, a malfunction may occur.
Copy (paper)
Stapling position
Set paper in the top bin, check the stapling position, and insert the
paper until it makes contact with the bin edge.
When the display lamp of the staple key is lighted, press the staple
key.
Remove the paper in the top bin, and check that stapling is made
properly.
If stapling is not made, repeat the above procedures.
With the above procedures, installation of the staple sorter is com-
pleted.
6 1
CA
The mode is set with the
above operations.