Table of Contents
Advertisement
RadioPro IP Gateway
3. C
ONFIGURATION AND
Use the steps in the following table to install a RadioPro System. Each step is discussed in detail starting on Page
Following installation of the IP Gateway in Step 5, at least one Client must be installed from Step 6.
Step #
Description
Configure Control Station Radio(s) for Voice
3.1.1
Configure Control Station Radio(s) for Data
3.1.2
Configure Subscriber Radios for ARS, GPS, and TMS
3.1.3
Connect RadioPro IP Gateway to Control Station Radio
3.2
Configure RadioPro IP Gateway(s) using ICU.exe
3.3
Please Refer to the
RadioPro IP Gateway Installation Guide
system types.
3.1 Program the Control Station Radio
3.1.1 Configure the Voice Radio
(For NX-700/800 radios see document # S2-61904.)
Radio models NX-5700/5800 can be used as a control station radio.
Use the KPG-D1N FPU (Kenwood's NEXEDGE 'Field Programming Utility' configuration software for NX-7x0/8x0
radios) to configure NEXEDGE radio parameters using the following steps.
Installation and Configuration Guide NEXEDGE NX-57xx/58xx
I
NSTALLATION
for additional installation steps relevant for all radio
6
Kenwood NEXEDGE NX-57xx/58xx
page
6
page
14
page
15
page
21
page
22
Kenwood FPU
6.
Advertisement
Table of Contents
