Messages And Error Codes - Electrolux Smart Service Manual

Messages and Error codes

Messages
Red LED in START
The following text appears in the
display:
TILTING
Xh XXmin XXX°C
AGITATOR 000rpm
AGITATOR
GRID ON
Buzzer sounds and the following
text appears in the display:
ELEMENT
OVERHEATED
INTERRUPT?
PRESS STOP
YES
PRESS START
NO
The agitator has stopped
The following text appears in the
display:
OVERLOADED
SHUT-OFF BOILING PAN
DURING APPROX. 1 MIN
PT-1000 FOOD
INTERAPTION
PT-1000 FOOD
SHORT-CIRCUIT
PT-1000 ELEMENT
INTERAPTION
PT-1000 ELEMENT
SHORT-CIRCUIT
WATER
INTERAPTION
SET WATER
UNSETTABLE DURING
WATER FILLING
The Reset button is lit.
16
The pan is not in working
flashing.
position.
End limit switch S11 broken
The grid is fully or partially
open.
Overheating of the heating
element. In the event of a fault
in the element sensor, the
heat is switched off.
STOP
during operation.
Overloaded agitator
Open-circuit in the PT-1000
sensor
Short-circuit in the PT-1000
sensor
Open-circuit in the PT-1000
sensor
Short-circuit in the PT-1000
sensor
Fault in the water meter
or
no water arriving at the pan
Manual filling with water
in progress
The boiling pan has been
without power /the emergen-
cy button is pressed
Cause
Press Tilt return
Close the grid and press Agitator start
• Press On/Off
• Wait for 5 seconds!
• Press On/Off
If the warning remains lit:
• Press On/Off
The display goes out.
Check water level, sensor and the PCB values
Follow the instructions in the display.
• Press STOP
has been pressed
or
• Press START
• Press On/Off
The display goes out.
Wait for approx. 1 minute
Increase the agitator speed
or
Reduce the amount of food in the pan
• Press On/Off
Check and replace if defective
Check and replace if defective
Check and replace if defective
Check and replace if defective
Check the taps and the water meter and repla-
ce if defective
Press STOP
water.
Reset the emergency stop and push the reset
button. The error is remaining, contact service
personnel.
Action
.
. The display goes out.
. The display is lit.
to switch off the pan.
to interrupt.
to go back to the program.
. The display is lit.
to interrupt manual filling with
.