Siemens S7-1200 Manual page 27

4 Configuration/Engineering
Step
6. Assign the variables to the
corresponding parameters of the
LCCF_EnetScanner.
7. Compile and download the program to
the PLC.
If it hasn't been already, put the PLC
into RUN Mode.
After this procedure the PLC should be running and executing the
LCCF_EnetScanner function block in a cyclic interrupt.
The use of a cyclic interrupt helps maintaining an execution in a more stable
interval. With this the update rates do not differ too much, and the jitter is kept to a
minimum.
EtherNet/IP Scanner
Entry-ID: 109782314, V1.1.0,
Instruction
04/2021
Result
The LCCF_EnetScanner is now
parameterized with its minimum set of
parameters.
27