Block Status Messages - Siemens S7-1200 Manual

6 LCCF_EnetScanner block
6.1.1

Block status messages

The LCCF_EnetScanner block reports a status information to the user, which
follows a standardized pattern.
The status code is split into the error flag and a status information value.
Table 6-3: Error and status message format
15 14
Error Info/ Warning
16#7 = Information
16#8 = Error
The LCCF_EnetScanner reports specific status codes. They are listed and
explained in the following table.
Table 6-4: status messages
Valid
TRUE
FALSE
FALSE
TRUE
TRUE
TRUE
TRUE
EtherNet/IP Scanner
Entry-ID: 109782314, V1.1.0,
12 11
Class Code
0 = Information
2 = Parameter
related
4 = Internal Cause
6 = External Cause
Busy Error Status
Code
(in hex)
TRUE FALSE 16#0000
FALSE FALSE 16#7000
TRUE FALSE 16#7001
TRUE FALSE 16#7002
TRUE FALSE 16#7202
TRUE FALSE 16#72x7
TRUE FALSE 16#72x8
04/2021
8 7
Specific Status Codes
Cause
Success/ OK --
No Call/ Idle Block is called with
enable = FALSE.
Create rising edge on
enable to start
execution
Initial call Block starts
initialization and
performs parameter
check
Follow Up call Block continues
operation
More data areas Adjust the array
have been boundaries for the data
parameterized, area to be the same as
than adapter have the adapter definitions.
been configured
When keep operating,
the excessive data
areas are not touched
and remain
unchanged.
Parameterized This warning indicates
RPI was at least an overload and should
once exceeded by be avoided by
the adapter[x]. increasing the RPI.
Scanner cannot This warning indicates
realize the desired an overload situation
update rate for on the scanner side
adapter[x] and should be avoided.
This can be achieved
by increasing the RPI.
0
Remedy
38