Panasonic TH-103PF12W Operating Instructions Manual page 18

Basic Controls
Remote Control Transmitter
R button (see page 23)
Press the R button to return to previous menu screen.
Standby (ON / OFF) button
The Plasma Display must fi rst be plugged into the wall outlet
and turned on at the power switch (see page 14).
Press ON to turn the Plasma Display On, from Standby mode.
Press OFF to turn the Plasma Display Off to Standby mode.
N button
(see page 27, 28, 29, 35)
POSITION buttons
ACTION button
Press to make selections.
POS. /SIZE button
(see page 25)
PICTURE button
(see page 28)
INPUT button
Press to select INPUT1, INPUT2,
INPUT3 and PC input SLOTS
sequentially. (see page 16)
When a dual input terminal
board is attached, A or B is
displayed depending on the
selected input signal.
(Ex. INPUT1A, INPUT1B)
Sound mute On / Off
Press this button to mute the sound.
Press again to reactivate sound.
Sound is also reactivated when
power is turned off or volume
level is changed.
Numeric buttons
(see page 46)
ASPECT button
Press to adjust the aspect.
(see page 19)
SURROUND button
The surround setting switches on and off each time the
SURROUND button is pressed.
The benefi ts of surround sound are enormous. You can
be completely enveloped in sound; just as if you were
at a concert hall or cinema.
18
Status button
Press the "Status" button to display
the current system status.
Input label
1
Aspect mode (see page 19)
2
NANODRIFT Saver operating
(see page 40)
Off timer
3
The off timer indicator is displayed
only when the off timer has been set.
Clock display (see page 58)
4
SET UP button (see page 23)
SOUND button (see page 34)
DIRECT INPUT buttons
Press the INPUT "1", "2", "3" or "PC"
input mode selection button to select
the INPUT mode. (see page 16)
This button is used to switch directly
to INPUT mode.
Volume Adjustment
Press the Volume Up "+" or Down
"–" button to increase or decrease
the sound volume level.
Channel Adjustment
This button cannot be used for this
model.
OFF TIMER button
The Plasma Display can be preset
to switch to stand-by after a fi xed
period. The setting changes to 30
minutes, 60 minutes, 90 minutes
and 0 minutes (off timer cancelled)
each time the button is pressed.
When three minutes remain, "Off
timer 3" will fl ash.
The off timer is cancelled if a power
interruption occurs.
Remote ID lock (see page 46)
Digital Zoom (see page 22)
MULTI Window buttons
(see page 20)
On Off
Surround On
PC
4:3
NANODRIFT
1 0:0 0
4
Off timer 90
30 60 90
0
1
2
3