Network Setup - Panasonic TH-103PF12W Operating Instructions Manual

Network Setup

Make the various settings to use the network function.
Setup
MULTI DISPLAY Setup
MULTI PIP Setup
Portrait Setup
Set up TIMER
PRESENT TIME Setup
Network Setup
Display orientation
Network Setup
Save
DHCP
IP address
Subnet mask
Gateway
Port
LAN Speed
Network ID
Control I/F Select
MAC address
Save
Save the current network Setup. Each value set for
DHCP, IP address, Subnet mask, and Gateway will be
saved. If "NG" is displayed, check the same IP address
is not used within the same network.
DHCP (DHCP client function)
To obtain an IP address automatically using a DHCP
server, set this to "On". If DHCP server is not used, set
this to "Off".
IP address (IP address display and setting)
Enter an IP address if DHCP server is not used.
Subnet mask (Subnet mask display and setting)
Enter a subnet mask if DHCP server is not used.
Gateway (Gateway address display and setting)
Enter a gateway address if DHCP server is not used.
Notes:
• To use a DHCP server, make sure the DHCP server is started.
• Contact your network administrator for details on settings.
2/2
DHCP, IP address, Subnet mask, and Gateway settings
1
Set DHCP.
When "Off" is selected, IP address and other settings can be set
manually.
2
Select the item and press
3
Landscape
Enter an address.
IP address
4
Select "Save" and press
Off
192.168. 0. 8 Port setting
255.255.255. 0
1
Select "Port" and press
192.168. 0. 1
2
Enter a port number.
1024
Auto Port
0
RS-232C
--:--:--:--:--:--
Use
1
I
192.168. 0. 8
Use
2
Press
3
Pressing
Use
1
I
01024
Use
2
Press
3
Pressing
Port
Set the port number used for command control.
The available setting range is 1024 – 65535.
When the PJLink™ protocol is used, the port setting is
not necessary.
LAN Speed
Set the connection speed of the LAN environment.
Select the value from Auto, 10 Half, 10 Full, 100 Half or
100 Full.
Network ID
Set the ID to identify this unit.
The available setting range is 0 – 99.
Control I/F Select
Set whether to control with RS-232C (serial) or LAN.
When "LAN" is set, the slot power is turned on, and power
indicator is lit orange under the condition of power "Off"
with remote control (stand-by state), regardless of the
"Slot power" setting. (see page 58)
MAC address
Display the MAC address of this unit. However, the MAC
address is not displayed when the "Control I/F Select" is
set to "RS-232C".
.
to select a digit.
to change a number.
.
will cancel the address change.
.
.
to select a digit.
to change a number.
.
will cancel the port number change.
55