Accessories; Accessories Supply; Remote Control Batteries - Panasonic TH-103PF12W Operating Instructions Manual

Accessories

Accessories Supply

Check that you have the accessories and items shown
Operating
Instruction
book
Ferrite core × 2
Use the Ferrite cores and Noise cut fi lter to
comply with the EMC standard. (see page 61)

Remote Control Batteries

Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
Remote Control
Batteries for
Transmitter
the Remote
EUR7636070R
Control
Transmitter
(R6 Size × 2)
Noise cut fi lter
2. Insert batteries - note correct
polarity (+ and -).
+
"R6" size
Power supply cord
Eyebolt cap × 3
Blind sheet × 1
-
+
-
Fixing band
× 2
Allen wrench
3. Replace the cover.
9