NEC N8151-74 User Manual page 65

Fixing the Built-in DVD-RAM drive in 5.25-inch device bay directly without
installation of rails on the Built-in DVD-RAM drive
Turn off the power of the computer and pull out the power cord from the AC inlet.
1.
Remove the proper covers on the computer. (Refer to the manual attached to the
2.
computer for details.)
Insert the Built-in DVD-RAM drive into the 5.25-inch device bay.
3.
Fix the Built-in DVD-RAM drive to the 5.25-inch device bay with the four screws
4.
coming with the Built-in DVD-RAM drive, or M3 screws having screw length of 6
mm.
Fix the Built-in DVD-RAM drive to the 5.25-inch device bay with two screws on
each of the left and right sides.
(factory installed in the computer)
Built-in DVD-RAM Drive
ODD
Screws (2)
Locate the Built-in DVD-RAM drive so that the front face
is aligned with those of other devices.
Left side
ODD
(factory installed in the computer)
Built-in DVD-RAM Drive
Screws (2)
Right side
55