Preparing The Remote Control Unit; Installing The Batteries; Remote Control Operation Range - Sharp PN-Y556 Operation Manual

Preparing the Remote Control Unit

Installing the batteries

1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.

Remote control operation range

Remote control sensor out
Point the remote control toward the remote control sensor on the front of the monitor.
For the monitor in landscape orientation
16.4 feet
(5m)
10º
10º
Remote control sensor in
The remote control can be operated even when the remote control sensor is stored inside the monitor.
Point the remote control toward the remote control sensor on the bottom of the monitor (or the right side of the monitor if using
portrait orientation).
For the monitor in landscape orientation
9.8 feet
(3m)
35º
TIPS
• Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a malfunction.
• Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.
• The remote control unit may not work properly if the remote control sensor is under direct sunlight or strong lighting.
• Objects between the remote control unit and the remote control sensor may prevent proper operation.
• Replace the batteries when they run low as this may shorten the remote control's operation range.
• If a fluorescent light is illuminated near the remote control unit, it may interfere with proper operation.
• Do not use it with the remote control of other equipment such as air conditioner, stereo components, etc.
Remote control
sensor
16.4 feet
(5m)
10º 10º
9.8 feet
Remote control sensor
(3m)
10º10º
TIPS
• When the batteries become exhausted, replace them with
new (commercially available) batteries.
• The supplied batteries (R-6 ("AA" size) x 2) may become
exhausted quickly depending on how they are stored.
• If you will not be using the remote control for a long time,
remove the batteries.
• Use manganese or alkaline batteries only.
For the monitor in portrait orientation
10º
10º
16.4 feet
(5m)
For the monitor in portrait orientation
10º
10º
9.8 feet
(3m)
Remote
control sensor
16.4 feet
(5m)
10º 10º
Remote
control sensor
9.8 feet
(3m)
10º
35º
10º
17
E