Table of Contents
Advertisement
VARI❋LITE - VL6000 B
Installing in Truss:
Step
1. Using two people, lift luminaire into mounting position.
Step
2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g. wing bolt) is properly tightened and
Step
3. Attach safety cable (as required) as follows (refer to Figure 11):
Safety Cable Anchor Point
(see note)
Note, truss hooks shown are sold separately. Truss and pipe by others.
Step
4. Make sure tilt and pan locks are disengaged so luminaire moves freely.
Step
5. Connect power and data cables according to procedure given in
When hanging the luminaire in a side hang position, orient the enclosure as shown in Figure 12. Natural convection and the designed
direction of the inlet and exhaust cooling fans dictate that the inlet should be closest to the floor and the exhaust should be towards the
13
L
Q
EAM
UMINAIRE
UICK
that luminaire is fully supported.
a.
Loop safety cable at least once around safety cable anchor point rod.
b.
Loop safety cable at least once around truss/pipe and secure around pipe.
Safety Cable: Recommended for hanging installations. May be required by local codes. Safety cable is sold
separately.
Câble de sécurité: Recommandé pour les installations pendaison. Peut être exigé par les codes locaux.
Câble de sécurité est vendu séparément.
23.8"
(60.5 cm)
Figure 11: Safety Cable Installation / Luminaire Hanging
S
G
TART
UIDE
24.5"
(62.2 cm)
23.8"
(60.5 cm)
Safety Cable Anchor Point
NOTE: The safety cable anchor point is tested and is in compliance
of the following safety standards:
- IEC / EN 60598-2-17.6.6
- UL1573
"Connecting Data" on page
27 A pr i l 2 0 1 7
25.9"
(65.9 cm)
7.
0 2 . 9 7 0 8 . 0 0 0 1
Advertisement
Table of Contents
