Torque Values - Panasonic NA-127VC6WFR Service Manual

FAILURE
Excessive foam in
the detergent
drawer
The washing result
is bad.
The washing result
is not good.
The water is seen
in the drum during
washing.
There are residues
of detergent on the
clothes.
There are grey
stains on the
clothes.
The spinning
process is not done
or starts with delay.
9. Critical Torque Values
Assembly Locatıon
*
Transport Screw Assembly
*
Motor Assembly
Front Concrete Weight - Front Tub
*
Assembly
*
Upper Counter Weight Assembly
Pulley – Drive Shaft – Washing Group
*
Assembly
*
Heater Assembly
The bolts/nuts above are important for product safety purposes. Please tighten screw, bolts and nuts according to the torque values given in
table above.
PROBABLE CAUSE
Too much detergent has been
used.
Wrong detergent has been used.
Laundry too dirty for the program
you have selected.
The amount of detergent used is
not sufficient.
Clothes exceeding the maximum
capacity has been filled in machine.
Water may be hard.
Distribution of the clothes in
machine is not well-balanced.
No failure. The water is at the lower
part of the drum.
The pieces of some detergents
which do not dissolve in water may
stick to clothes as white stains.
These stains may be caused by oil,
cream or ointment.
No failure. The unbalanced load
control works in that way.
Bolt/Nut
Transport Screws
Motor Screws
Front Counterweight Screws
Upper Counter Weight Screws
Pulley – Drive Shaft Assembly
Bolt
Heater Assembly Nut
METHODS OF ELIMINATION
Press the start/pause button. In order to stop
the foam, dilute one table-spoon of softener in
half liter of water and pour it in the detergent
drawer. Press the start/pause button after 5-10
minutes. Arrange the amount of the detergent
properly in the next washing process.
Use only the detergents produced for full
automatic machines.
Select a suitable program.
Use more detergent according to the
detergent.
Put the clothes in machine in a manner not to
exceed its maximum capacity.
Use the amount of detergent according to the
declaration of the detergent producer.
Spread the clothes inside the machine in an
orderly and well-balanced manner.
By calibrating machine for "Rinsing" program,
make an additional rinsing or eliminate the
stains After drying with the help of a brush.
In the next washing operation, use the
maximum detergent amount declared by the
detergent producer.
The unbalanced load control system will try to
distribute clothes in a homogenous manner.
After clothes are distributed, passage to
spinning process will be realized. In the next
washing process, place clothes into the
machine in a well-balanced manner.
Torque Min. Torque Nom.
(Nm)
6.50
6.00
14.00
25.00
39.50
3.85
14
Torque Max. Air Pressure
(Nm) (Nm) Wrench (rpm)
6.50 7.00
6.50 7.50
14.50 14.75
27.50 30.00
40.00 40.50
4.00 4.00
1000
800
600
440
440
970