Panasonic NA-127VC6WFR Service Manual page 7

4.1.4. Water Supply Connection
1. Washing machine is supplied with a single (cold) water inlet.
2. To prevent leakage from the connection joints, a rubber
washer is included in the hose packing. Fit this washer at the
end of water inlet hose on the tap side.
3. Connect the hose to the water inlet valve. Tighten the plastic
connector by hand. Please call a qualified plumber if you are
unsure about this.
4. Water pressure of 0,1-1 MPa from tap will enable machine to
work more efficiently.(0,1 MPa pressure means water flow of
more than 8 litres in 1 minute from a fully opened tap)
5. After connection is complete, check for leakage by turning on
tap completely.
6. Make sure that water inlet hoses can not become folded,
damaged, stretched or crushed when the washing machine is in
its final position.
7. Mount the water inlet hose to a ¾" threaded water tap.
4.1.5. Drain Connection
1. Make sure that water inlet hoses are not folded, twisted,
crushed or stretched.
2. The drain hose should be mounted at a minimum height of 60
cm, and a maximum height of 100 cm from the floor.
3. The end of the drain hose can be connected directly to a
drainage stand-pipe or alternatively to a specific connection point
designed for that purpose on the waste outlet of a sink unit.
4. Do not extend the drain hose or guarantee will be invalidated.
4.2 Detergent Box Group
MAIN
SOFTENER
PREWASH
PREWASH = WATER ENTRY VALVE 1
MAIN = WATER ENTRY VALVE 2
SOFTENER = WATER ENTRY VALVE 1 + VALVE 2
VALVE1
VALVE1
VALVE2
7