Smart Card Reader Board - HP EliteBook 725 G4 Maintenance And Service Manual

Smart card reader board

Description
Smart card reader board (includes cable)
Before removing the card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unscrewing the power cord from the AC outlet, and
then unscrewing the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the system board (see
Remove the smart card reader board:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
installed.
1. Disconnect the cable from the board (1).
2. Disconnect the cable from the TouchPad (2).
3. Remove the 3 Phillips PM2.5x3.0 screws that secure the bracket to the top cover (3), and then lift to
remove it from the computer (4).
4. Lift the smart card reader board left to remove it from the top cover (5).
Reverse this procedure to install the card reader board.
58 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 36).
System board on page
33).
49).
Spare part number
914963-001