Parameter
Username
Password
Access interval
4.3.5
IP filter
The IP filter interface is shown as in Figure 4-18.
You can enable IP filter function so that some specified IP/MAC user can access the network camera.
You can add IP address or IP address section.
If you do not check the box here, it means there is on access limit.
Here you can add IP address and MAC address. You must add these addresses before enabling the
trusted sites.
Please note: You must set MAC address in the same network segment.
Function
The user name you input to log in the server.
The password you input to log in the server.
Device sends out alive signal to the server regularly.
You can set interval value between the device and DDNS
server here.
Figure 4-13
44