Toro 74255 Operator's Manual page 17

There is no rollover protection when the roll
bar is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll
bar is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e. branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
Important: Lower the roll bar only when
absolutely necessary.
1. To lower the roll bar, loosen the front knobs
(Figure 6).
Figure 6
1. Front knob
2. Remove the hairpin cotter pins and remove the
two pins (Figure 8).
3. Lower the roll bar to the down position. There
are two down positions. See Figure 7 for the
positions.
1. Full down position
4. Install the two pins and secure them with the
hairpin cotter pins (Figure 8).
Important: Ensure that the rear part of
the seat is secured with the seat latch.
5. To raise the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 8).
6. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 8).
Important: Always use the seat belt with
the roll bar in the raised position.
17
Figure 7
2. Down position with bagger
installed