Adjusting The Mower Belt; Tension - Toro 74255 Operator's Manual

Important: Check the amount of twist
in the belt between the pulleys. Make sure
it is only what is specified in Figure 55.
Figure 55
1. Clutch
2. Mower belt
3. 1/4 turn belt twist
6. Adjust the belt tension, refer to Adjusting the
Mower Belt Tension.
7. Install the belt covers and close the latches
(Figure 56).
Figure 56
1. Belt cover
2. Latch
4. Belt guide
5. Mower spindle pulley
6. Mower idler pulley
3. Insert slot into the tab

Adjusting the Mower Belt

Tension

1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Raise the mower to the transport position.
Important: Check the amount of twist
in the belt between the pulleys. Make sure
it is only what is specified in Figure 55.
Important: Check and make sure the
belt is installed into both the front and rear
belt guides (Figure 57).
4. Check the belt tension. The spring loaded idler
center bolt needs to be near the top alignment
hole in left support plate (Figure 57).
Figure 57
1. Center bolt
2. Alignment hole
5. If adjustment is required, loosen the mower
idler plate and adjust it (Figure 58).
44
3. Left support plate
4. Spring loaded idler