JVC LX-WX50 User Manual page 33

iii. You can adjust the LAN Settings.
iv. Once set, access to the remote network operation page on this projector has been
password-protected. To enable this function, check the box in front of "Enable" and type
in your desired password in the New Password column and confirm the new password
by re-entering the new password at the Confirm column. To disable password protection,
uncheck the box.
v. Once set, access to the Tools page has been password-protected. Refer to step iv for
how to use the password function.
vi. Press Exit to go back to the remote network operation page.
After making the adjustments, press the Send button and the data will be saved in the
projector.
Once the password is set, the Log Out button will display beside the Tools button.
Write down your selected password in advance or right after the password is entered so that
it is available to you should you ever forget it.
If you did not write down your password, and you absolutely do not remember it you can reset
the password by following procedure.
• Open log in screen of e-Control™ by your web browser.
• Long press on MENU and
• Now the password has been reset.
The software is available in English language.
When DHCP is turned on, there is a possibility of stopping the webpage connection. If this
happens, please check the new IP address of the projector and enter the new address to
connect again.
4. The Info page displays the information and status of this projector.
i. The information you entered in the Tools page will display here and these columns are
empty when you use e-Control™ for the first time.
ii. When the projector is in abnormal conditions, the following information will display.
Error Status
0: No Error
3: Lamp fail
3: Over Temp
3: Fan Lock
3: Over Lamp Usage Time
on the projector for 3 seconds.
i
i
iii
The projector is in normal conditions or in any abnormal
conditions other than the ones mentioned below.
The lamp fails to ignite or turns off during operation.
The projector temperature is too high or cannot be detected.
The fan rotation speed cannot be set or detected.
The lamp is still in use after the lamp warning messages display.
ii
Description
Controlling the projector remotely 33