Changing The Orientation Of The Main Unit Of The Projector - Panasonic et-jpc100bu Installation Instructions Manual

Installation (continued)

Changing the orientation of the main unit of the projector.

This section describes changing the orientation of the main unit of the projector to make the mounting work of the
projector mount bracket easier to do.
Rotating fi xing
4) Tighten the fi xing screw.
 Tighten the rotating fi xing screw with the 7/64" Allen wrench supplied with the projector to prevent the main
unit moving during the mounting work.
Note
 The rotating fi xing screw is a hexagon socket head screw (M6). Take care because it will come out of the
projector if loosened too much.
18 - ENGLISH
screw
Shaft holder
Main unit
1) Place the projector on a cloth or the like that
has been laid on a fl at surface.
2) Loosen the fi xing screw.
 Loosen the rotating fi xing screw of the projector
with the 7/64" Allen wrench supplied with the
projector.
3) Change the orientation of the main unit.
 Loosening the rotating fi xing screw enables
rotation of the shaft holder so that the
orientation of the main unit can be changed.