Panasonic VL-SWD273 Installation Manual page 14

Main monitor/extension
monitor installation position
About the installation position of the main
monitor/extension monitor and mounting
bracket
R Place the main monitor/extension monitor in a
location that your eyes are the same height as
the centre of the display.
R For the following reasons, leave at least 20 cm
(A) of space above, below, and to the left and
right sides of the main monitor/extension
monitor:
– To prevent malfunction and sound cutting out
– To ensure to make sure the reset button (B)
can be used (the reset button is on the bottom
of the main monitor/extension monitor)
1
1
1
R After deciding where to install the main monitor/
extension monitor, attach the mounting bracket
in the location shown below.
D
E
C
C Main monitor/extension monitor installation
position
D 121.5 mm
E 58 mm
14
1
2
Installing the main monitor/
extension monitor
1
Attach the mounting bracket (A) to the wall
securely.
R Install the mounting bracket on a vertical flat
wall (B).
A
C
C Screws (accessory)
D Hole in wall E 60 mm F 83.5 mm
G 7 mm H 50 mm
2
Connect the DC cable and wires.
R Connect the wires correctly according to
"Wiring schematic diagram".
2-1 How to connect the DC cable
A Remove screw A (A) and then remove the
terminal cover.
B While pressing on the button (B) with a
pointed object such as a screwdriver, insert
the wires of the DC cable into the terminal
connectors (non-polar).
C Make sure to replace the terminal cover.
2-2
E
Bare wire at tip: C 11 mm D 42 mm
E Wiring from power supply unit
B
D
E
F
G
H
2-1
A
2-2
C
B
D