JVC UX-A52 Service Manual page 23

Removing the head assembly / head
board (See Fig.9 and 10)
Prior to performing the following procedure, remove
the side bracket (L), (R), cassette hanger assembly /
cassette holder.
1. Remove the spring on the lower side of the head
assembly.
2. Remove the two screws D and remove the head
assembly upward.
3. Remove the screw E
Unsolder the flexible wire extending from the head
assembly if necessary.
Removing the flywheel assembly (F) and
(R) (See Fig.11 and 12)
Prior to performing the following procedure, remove
the side bracket (L), (R), cassette hanger assembly /
cassette holder.
1. Remove the belt and sub belt on the bottom of the
body.
2.
Remove the polywasher from the flywheel (F) and
(R) on top of the body.
3. Pull out the flywheel (F) and (R).
attaching the head board.
Fig.9
Head board
Fig.10
Sub belt
Flywheel assembly (R)
Fig.11
Polywasher
Fig.12
Head assembly
D D
Head assembly
Soldering
E
Belt
Flywheel assembly (F)
Polywasher
UX-A52
1-23