Download Print this page
Kenwood NEXEDGE NXR-900 Instruction Manual

Kenwood NEXEDGE NXR-900 Instruction Manual

800mhz digital base-repeater/ 900mhz digital base-repeater

Advertisement

Quick Links

NXR-900/ NXR-901
800MHz DIGITAL BASE-REPEATER/ 900MHz DIGITAL BASE-REPEATER
INSTRUCTION MANUAL
BASE-RELAIS NUMÉRIQUE 800MHz/ BASE-RELAIS NUMÉRIQUE 900MHz
MODE D'EMPLOI
BASE-REPETIDOR DIGITAL 800MHz/ BASE-REPETIDOR DIGITAL 900MHz
MANUAL DE INSTRUCCTIONES
© B62-2410-00 (K)
09 08 07 06 05 04 03 02 01 00

Advertisement

loading

Summary of Contents for Kenwood NEXEDGE NXR-900

  • Page 1 NXR-900/ NXR-901 800MHz DIGITAL BASE-REPEATER/ 900MHz DIGITAL BASE-REPEATER INSTRUCTION MANUAL BASE-RELAIS NUMÉRIQUE 800MHz/ BASE-RELAIS NUMÉRIQUE 900MHz MODE D'EMPLOI BASE-REPETIDOR DIGITAL 800MHz/ BASE-REPETIDOR DIGITAL 900MHz MANUAL DE INSTRUCCTIONES © B62-2410-00 (K) 09 08 07 06 05 04 03 02 01 00...
  • Page 2: Notices To The User

    NXR-900/ NXR-901 INSTRUCTION MANUAL 800MHz DIGITAL BASE-REPEATER/ 900MHz DIGITAL BASE-REPEATER THANK YOU! We are grateful you purchased this KENWOOD repeater. We ◆ This repeater is intended for use as a fixed base station with believe this easy-to-program repeater will be highly effective in...
  • Page 3: Controls And Functions

    CONTROLS AND FUNCTIONS ■ Front Panel STATUS 3 4 5 6 7 8 VOLUME MON TAKE OVER DISABLE CTRL OCXO BUSY POWER MICROPHONE OFF/ q Speaker While blinking, the repeater cannot be used. w CH/STATUS Display TX indicator Two 17-segment digits display the channel number, name, Lights red while transmitting.
  • Page 5 Addendum Terminal Description MIC (Modular Jack) Control I/O (D-SUB 25 Pin) CONNECTOR Pin Name Description Specification Notes Pin Name Description Specification Notes Not used Not used − Not used Not used − Power Output 13.8 V Not used Not used −...
  • Page 6 MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND USERS • Use only manufacturer or dealer supplied antennas. • Antenna Minimum Safe Distance: 30 cm (1 foot). • Antenna Gain: 0 dBd referenced to a dipole. The Federal Communications Commission has adopted a safety standard for human exposure to RF (Radio Frequency) energy which is below the OSHA (Occupational Safety and Health Act) limits. • Antenna Mounting: The antenna supplied by the manufacturer or radio dealer must not be mounted at a location such that during radio transmission, any person or persons can come closer than the above indicated minimum safe distance to the antenna, i.e. 30 cm (1 foot). • To comply with current FCC RF Exposure limits, the antenna must be installed at or exceeding the minimum safe distance shown above, and in accordance with the requirements of the antenna manufacturer or supplier. • Vehicle installation: The antenna can be mounted at the center of a vehicle metal roof or trunk lid, if the minimum safe distance is observed. • Base Station Installation: The antenna should be fixed-mounted on an outdoor permanent structure. RF Exposure compliance must be addressed at the time of installation.

This manual is also suitable for:

Nexedge nxr-901