Advertisement
5. MAINTENANCE
Note: Numbers/letters in brackets refer to those on the parts diagram.
WARNING! Disconnect the tool from the air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1.
If the compressed air system does not have an integral oiler then lubricate the tool daily with
a few drops of Sealey air tool oil dripped into the air inlet.
5.2.
Regularly check oil, and top-up if necessary, via the oil plug (13). Use Sealey Hydraulic Jack
Oil, Part No. HJO/500ML, HJO/5L or HJO/25L.
5.3.
Clean the tool after use.
5.4.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type
of hose connectors. To remedy, check the air supply and follow instructions in Section 3.
b) Grit or gum deposits in the tool may also reduce performance. If your model has an air
strainer (located in the area of the air inlet), remove the strainer and clean it. Flush out
the tool with gum solvent oil or an equal mixture of SAE 10 oil and paraffin. Allow to
dry before use.
5.5.
For a full service contact your local Sealey service agent.
5.6.
To remove and replace the punch (6) and/or die (3) proceed as follows:
1) Remove screws (7) and slide off cover plate (8).
2) Slacken set screw (2) and strike rear edge of clamp (1) with a soft-headed hammer in
order to unscrew it from the shaft of the hydraulic piston (31). If necessary the shaft may
be locked by removing the oil plug (13) and inserting a suitable rod into a hole in the
shaft.
3) Fully unscrew the clamp (1) and anvil (9) assembly from the shaft.
4) Separate the anvil (9) and the clamp (1) to replace the punch (6) and/or die. The die (3) is
a push fit in the clamp (1) and can be tapped out via the waste bore (A). Push/tap in the
replacement.
5) Reassemble the anvil (9), clamp (1) and the replacement punch (6)
and screw onto the shaft. Tap with a soft-headed hammer
to ensure tightness and lock with the set screw (2).
6) Refit the cover plate (8) and retain with
screws (7).
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
SA36.V2 Issue: 3(SP) - 05/09/13
Advertisement
