Husqvarna 120 Workshop Manual page 21

2
Compress the spring with a wide screwdriver (or
special tool 513 63 70-01) and press it down with
your thumb, see figure 7.
WARNING!
Exercise care to ensure the spring
does not fly out and cause personal
injury. Wear protective goggles.
3
Fit the two covers using 2 - 3 Nm tightening torque,
see figure 8.
4
Tension the spring by pressing down the lever. See
figure 9.
5
Assemble the handle in right position. Fit the screw
and tight the nut. See figure 9b.
6
Fit the guide bar, saw chain and clutch cover and
tighten the bar nuts. See figure 10.
Fig 7
Fig 8
Fig 9
Fig 9b
Fig 10
21
English -