Panasonic NP-6F2MUQNZ Operating And Installation Instructions page 21

Stand-alone dishwasher
Table of Contents

Advertisement

Using the Dishwasher
Note:
• *AS/NZS 2007.1 : This program is the test cycle. The information for comparability test
in accordance with AS/NZS 2007.1, as follows:
Capacity: 14 place settings
Position of the upper basket: lower
Programme: ECO
Detergent(Pre/main): 5 g / 27.5 g
Rinse aid setting: 6
• The combination with the pre-wash detergent, and its quality of the effect may vary
according to the detergent manufacturer. Consult the manufacturer upon purchase of
the detergent.
Starting a Wash Cycle
1. Insert Power Plug to the mains socket. Switch ON the main switch on the wall. Fully
open the Dishwasher door.
2. Fill in the detergent and rinse aid.
3. Draw out the Lower Basket, Upper Basket and Cutlery Basket. Load the dishware to
the baskets and push them back.
4. Fully close the Dishwasher door. Turn ON the water supply.
5. Turn ON the Dishwasher by pressing OFF/ON button follow by the Programme
Selection button. The default wash programme is ECO and the wash sequence will
be:
Eco --> Glass --> 90 min --> Rapid --> Soak --> Auto --> Intensive --> Heavy
If a programme is selected, the icon light will light up and the time needed to run the
wash cycle will show on the Control Panel.
6. Press the Pause/Start button to start the washing.
(" : " in the time display will blink if the washing is started, " : " in the time display will
stop blinking when washing is stopped or paused.)
Changing the Programme
1. A cycle that is underway can be modifi ed only if it has been running for a short time.
Otherwise, the detergent may have already been released, and the Dishwasher may
have already drained the wash water. In this case, the detergent dispenser must be
refi lled (see the section titled "Fill in Detergent").
2. Press the Pause/Start button then press the Programme Selection button for more
than 3 seconds to cancel the running programme.
3. Select a new programme.
4. Restart the Dishwasher by pressing the Pause/Start button.
Note:
If the door is opened during a wash cycle, the Dishwasher will pause. When the door is
closed, the Dishwasher will resume working after approximately 10 seconds.
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents