Dell PowerVault 720N Installation And Troubleshooting Manual page 72

3-20 Dell PowerVault 720N, 740N, and 760N Installation and Troubleshooting Guide
Reporting SNMP traps and Set-
ting up SNMP trap host
Setting time from remote host
x default route
x route to y
The following SES error messages might also appear during system operation:
Drive placement ha x shelf y, No SES on shelf x ha y, Unsupported SES shelf x, ha y.


These messages appear briefly when the
filer is reporting to the SNMP manage-
ment host on SNMP trap conditions.
Refer to the Dell PowerVault 720N, 740N,
and 760N System Administrator and
Command Reference Guide for informa-
tion about SNMP administration and
setting up SNMP management
parameters.
This message appears briefly when the
filer is resetting its Time-of-Day Clock from
a remote time source. For more informa-
tion, see the command in the Dell
rdate
PowerVault 720N, 740N, and 760N System
Administrator and Command Reference
Guide.
These messages appear briefly when the
routing software is configuring the routing
table. For more information, refer to the
Dell PowerVault 720N, 740N, and 760N
System Administrator and Command
Reference Guide.