Bosch AUTODOME IP starlight 7000i Installation Manual page 28

28 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
Power Supply Box Connections
The following figure is a detailed illustration of the Pendant Arm Power Supply Box, which
includes the fuse specifications.
Figure 9.2: Pendant arm power supply box
1
2
3
4
5
6
Warning!
In earlier Bosch AUTODOME cameras, cable 8 in the ARM mount is labeled "Control In/Out"
and was used for external RxD/TxD and Biphase communications. In the AUTODOME 7000
!
Series cameras: If you are mounting an AUTODOME 7000 Series camera to an ARM mount
that was wired for an earlier model of Bosch AUTODOME, you must either re-wire cable 8 to
be audio input and output, or disconnected it from the power supply.
Cables/wires that are routed through number 2 in the illustration above come from the Nexus
cable bundle that is in the pendant Arm.
2021-03 | 1.2 |
TRANSFORMER
(115/230VAC
MODELS)
P101
LINE NC NEUT
1 2 3
P106
GND TXD RXD C+ C-
6 5 4 3 2 1
Ground Screw
From Harness (Nexus cable bundle) 8
In/Out; 1/2 in. (15 mm) NPS Fitting
Ethernet connector
P107 Connector; 24 VAC to camera
In/Out; 1/2 in. (15 mm) NPS Fitting
J102 J102 J102 J102
a
(LED)
P105
GND TXD RXD C+ C-
6 5 4 3 2 1
7 P101 Connector; Power In (120 VAC / 220
VAC)
P106 Connector; Control In/Out for external
audio input and output
9 P105 Connector; Audio to camera
10 Power In; 3/4 in. (20 mm) NPS Fitting
11 Audio Input/Output; 3/4 in. (20 mm) NPS
Fitting (labeled "SERIAL COMMUNICATIONS")
Installation Manual
AUTODOME IP starlight 7000i
Bosch Security Systems