Table of Contents
Advertisement
MKE
9.3
Transport and Handling
9-2
Storage , Transport and Handling
Motor damage and forfeiture of guarantee!
Improper transport and handling can damage the motor.
The guarantee is also forfeited in this case.
⇒ Please therefore follow the instructions below.
WARNING
Maintain the following conditions during transport and when handling:
⇒ Use suitable transport devices. Note the weight of the components
(weights are listed in the individual sections with the technical data of
the motor or on the type plates of the motor).
⇒ Shock damping should be used if excessive shocks are expected du-
ring transport. Note the limit data as outlined in section „2.2 Maximum
vibration and shock requirements, page 2-3".
⇒ Transport in horizontal position only.
⇒ When picking up the motor, use a crane or lifting belts
⇒ Motor flange and drive shaft must not be damaged!
⇒ Avoid impacts to drive shaft.
⇒ Protective cover made of plastic is on the drive shaft and must not be
removed until shortly before the motor is mounted.
Note:
If the motor is also equipped with a holding brake and, if prior
to mounting the holding torque listed in the data sheets is not
achieved, then refinish the holding brakes. Note the instructi-
ons in section 11.5 „Refinishing the holding brake", page 11-8.
Fig. 9-2: Lifting and transporting the motors with the use of lifting belts
DOK-MOTOR*-MKE*******-PRJ1-EN-E1,44 • 06.97
Advertisement
Table of Contents
