Table of Contents
Advertisement
Chapter 4
1. Switch ON all peripherals connected to the mainframe and if applicable Extenter mainframes
2. Switch ON the mainframe itself
Configured as a proprietary HP 81200 system (HP E4840A or HP E4849A/B), the Windows NT
automatic log-in script is enabled. After power on, you are automatically registered as user DVT
and the Windows desktop appears.
Configured as a open HP 81200 system you have to login as user or administrator defined for your
Windows NT operating system.
3. Select the kind of display you are using
The display driver is set to a mode that supports both CRT and the flat panel option. The resolution
is 640 x 480 pixels.
This should always be the first step after power on. Problems can arise, if you operate Windows or
the HP 81200 software without specifying your display.See
page 46
for more details.
4. Select the System Operating Mode
Depending on the operating modes LOCAL, CONTROLLED or REMOTE you can define which
software components need to be started.See
5. Start the system in a chosen operating mode.See
page 50
6. Verify your system
Start the System
"Select the System Operating Mode" on page
"Select your kind of Display" on
"How to Start the HP 81200 User Software" on
48.
45
Advertisement
Table of Contents
