Input And Output Parameters - Bosch Rexroth IndraControl S67 Manual

44/79 Bosch Rexroth AG
Parameterization
8.3

Input and Output Parameters

Rexroth IndraControl S67 Digital Module High Speed 4 Inputs/Outputs – 0.2 A (84×M12)
Global diagnostics Description
Undervoltage at
U
LS
Disabling the outputs.
In case of an undervoltage of U
puts are disabled. Machine components can be set to a dan‐
gerous state and endanger personnel as well as machine.
If there is an undervoltage of the logic supply (U
the module, the outputs are disabled and a diagnostics is sent
to the field bus coupler. The F-LED of the module is lit
Undervoltage at U
A
Disabling the outputs.
In case of an undervoltage of U
puts are disabled. Machine components can be set to a dan‐
gerous state and endanger personnel as well as machine.
If there is an undervoltage of the sensor/actuator supply (U
18 V) at the module, the outputs are disabled and a diagnos‐
tics is sent to the field bus coupler. The F-LED of the module is
lit
Short circuit/over‐ The module short-circuited or a field supply overload is detec‐
load field supply ted (only possible if field supply active)
Tab. 8-1: Information on existing module diagnostics
Channel diagnostics
Diagnostics Description
Overtemperature The module detected overtemperature at the corresponding
channel (only active in case of an active actuator output).
Possible reasons: Overtemperature, short circuit or overload at
the output level
Tab. 8-2: Information on a present channel diagnostics
Interrupting the S-BUS
When interrupting an S-BUS, the module automatically goes to
the STOP state. The module outputs are disabled.
Operation mode selection
Specifies the operation mode the module should be operated with. Using the
"DIO" operation mode, each connection can be individually parameterized as
digital input or output in IndraWorks.
DOK-CONTRL-S67DIO4M12H-AP02-EN-P
WARNING
and/or U
A
WARNING
and/or U
A
, the module out‐
LS
< 18 V) at
LS
, the module out‐
LS
<
A