Safety Notes - Panasonic PAW-160MAH2L Installation Instructions Manual

General information and safety notes
1.2

Safety notes

To avoid possible harm to persons or damage to products, read and follow these safety notes.
WARNING
The following precautions need to be followed strictly, in order to avoid hazardous situations, which
could result in death or serious injury.
1
Electric shock or fire may result from inadequate or incorrect installation or wiring
procedures.
► System installation must only be performed by an experienced electrician.
► Arrange installation at the dealer where the system was purchased or use a professional
► System installation must be performed in strict accordance to the installation procedures
Damage to the circuit breakers may result from incorrect electrical wiring, insufficient
electrical circuit capacity or use with other electrical devices.
► Always use a dedicated circuit for electrical wiring.
► Strictly avoid using other electrical devices within the same electrical circuit.
► Make sure the electrical circuit used has sufficient capacity.
Overheating or fire may result if connections or attachments are not secure.
► Use the specified cables (type and wiring diameter) for the electrical connections, and
► Run and fasten the cables securely so that external forces or pressure placed on the
Suffocation can result if refrigerant gas leaks and exceeds the limit density in a small room.
► Installation of the refrigerant piping must only be performed by an experienced, qualified
► Install so that even if refrigerant gas leaks into the installation space, it will not exceed the
► If the refrigerant gas concentration does exceed the density limit, do one of the following:
Poisonous gas can result if refrigerant gas comes into contact with fire.
► After installation of refrigerant pipes, perform a dry nitrogen gas sealing test to check that
► Ventilate the work area if refrigerant gas leaks during installation.
► Prevent the refrigerant gas from coming into contact with a fan heater, stove, range, or
8
installer.
described in this document.
securely connect the cables.
cables will not be transmitted to the connection terminals.
installer to minimize the risk of leaks.
practical limit density of 0.44 kg/m
with the local regulations for facility air conditioning equipment. However, for further limits
and calculations to be done, see
● install an opening in a neighbouring room
● or install ventilation equipment triggered by gas leak detection sensors
● or install an automatic shut off and/or pump-down system provided by the man-
ufacturer of the equipment
there are no leaks.
other source of ignition.
for R410A and 0.061 kg/m
3
→ 1.3 Instructions for the safe handling of R32, p. 9
AHU Kit – Installation Instructions – 09/2021
for R32, in accordance
3