Advertisement
Product warranty and after-sales service are only valid in Japan.
Preparation before use (P.3〜6)
Charge before first use.
How to charge (P.3)
Be sure to charge on a power source of 100 - 120V or
200 - 240V AC.
The recommended charging temperature is in the range of
10 – 35°C.
At a temperature below the recommended temperature, the
charging response may slow down, causing an insufficient
charge and a reduced number of operating times.
The standard charge time is 8 hours.
The shaver can be used for approximately 7 days on a single
charge (under three minutes' use a day).
The operating times may decrease depending on heaviness of
beards, force exerted on skin, maintenance status, and operating
conditions, such as ambient temperature.
Each battery has a service life.
(The battery life greatly varies according to the conditions of use
and storage.)
If the number of operating times is extremely small in spite of use
in accordance with the instructions, it is considered that the
battery life is about to expire. For battery replacement, consult
with your distributor or customer service representative listed on
page 24.
Never connect or disconnect to/from the outlet with wet hands.
(Cause of electric shocks or injury)
1. Set to your regional voltage.
Set to 100 - 120V for use in Japan.
Caution
Do not charge on voltage of 200 - 240V with the setting of
100 - 120V. (Cause of injury)
2. Turn the switch "OFF," and insert the power plug into an outlet.
Caution : When the switch is "ON," charging is disabled.
lights (red) while charging, and will not go out after
completion of charging. Even after a lapse of the
standard charge time (8 hours), the lamp remains
The charge indicator lamp
on due to slight charging.
Slide the voltage
selector knob
from side to side.
With a ballpoint pen, etc.
Turn the switch to "OFF."
32
20 0- 24 0V
10 0- 12 0V
Advertisement
