Areas Of Application; Fitting/Removing Attachments - Silvercrest SDR 1100 B2 Installation Instructions Manual

Areas of application

You can clean either by using steam directly from the steam nozzle
can fit an accessory.
NOTE
► The closer you hold the steam nozzle
better the effect. The steam pressure and temperature are at their highest
directly after leaving to the steam nozzle
► Stubborn stains and dirt must be soaked with water beforehand.
■ Use the squeegee attachment
■ Use the upholstery nozzle
armchairs.
■ Use the angle nozzle
■ Use the round brush

Fitting/removing attachments

WARNING! RISK OF INJURY!
► Always remove the plug from the mains power socket before you fit/remove
an attachment.
► Wait until the appliance has cooled down before you fit/remove an
attachment.
► Wait until all of the steam has dissipated before you fit/remove an
attachment.
Extension hose
♦ Push the extension hose
marking line on the extension hose
ance must be aligned with each other (see fig. A on the fold-out page).
♦ Turn anticlockwise until both marking lines on the extension hose
aligned with both marking lines on the appliance. The extension hose
remains locked in this position (see fold-out page Figure B).
NOTE
► The fixture on the appliance has a joint so that the attachment can be
aligned to the best usage position. This is, however, not possible with the
extension hose
■ The extension hose
■ 48 │ GB │ MT
13
to steam clean glass surfaces.
14
with the fabric cover for cleaning sofas and
12
for tight corners or joints, or hard-to-reach places.
11
for stubborn soiling, for example, on wheel rims.
9
onto the steam nozzle
9
9
.
9
is removed in the reverse order.
6
to the surface to be cleaned, the
6
.
6
up to the stop. The
and the marking lines on the appli-
SDR 1100 B2
6
or you
9
are
9