Plumbing Procedure - Beko BWI45S1D-242 User Manual

6

Plumbing Procedure

CAUTION !
This Instant Hot Shower is a single point system and the 'Water Outlet' can
only e fotted to the PVC Hose and Handshower set provided. NO CONTROL
VALVE OR FITTING CAN BE FITTED TO THE WATER OUTLET.
6.1 Connect the Stop Valve to the Water Inlet with rubber water. use
proper tools to tighten the connection and be careful not to break the
plastic nut.
6.2 Connect the incoming water piping to the Stop Valve (1/2" BSP).
Make sure to put the Mesh Filter between Stop Valve and incoming
water piping.
6.3 If in any case, the Stop Valve is not use or omitted, make sure to
put the Mesh FIlter between the heater unit inlet pipe and incoming
water pipe.
6.4 Turn on the water main to drain out all the plumbing dirts, at the same
time fill up the heater tank.
IMPORTANT
For Pump Model, it is highly recommended to connect Water Inlet
Connection to tank storage supply, otherwise it may cause damage to the
Pump Motor.
6.5 Turn on the water main to drain out all the plumbing dirts, at the same
time fill up the heater tank.
THE HEATER TANK MUST BE FILLED UP WITH WATER BEFORE
TURNING ON THE ELECTRICITY SUPPLT TO PREVENT ANY DRY
BURNT DAMAGE TO THE HEATING ELEMENT.
6.6 Connect the PVC Hose and Handshower tot he outlet of heater, be
sure to put in the Ruber Washer.
6.7 Hook the Handshower to the Slider Rail Shower Holder and adjust
to your ideal position.
6.8 Check if any water leakage.
6.9 Do not use white tape during installation.
WARNING !
6.10 THE WATER INLET AND OUTLET MUST BE INSTALLED
CORRECTYLY, OTHERWISE HEATER UNIT WILL NOT FUNCTION.
6.11 DO NOT APPLY PLUMBING CEMENT ON CONNECTION.
WHENEVER NECESSARY, USE ONLT THREAD OD SEALING TAPE.
9 / EN