Balance Shaft Removal / Inspection - Polaris RZR PRO XP 2020 Service Manual

h
14. Remove the eleven M6
crankcase bolts.
15. Rotate the engine so the cylinder is facing down.
k
16. Remove the one M6 , eight M10
lower crankcase bolts. Discard the eight M10 bolts.
17. Tap on the lower crankcase in reinforced areas with a
soft faced hammer to loosen. Carefully lift up and
remove the lower crankcase half.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
j
and two M8 upper
l 1(
and two M8
ENGINE / COOLING SYSTEM
BALANCE SHAFT REMOVAL /
INSPECTION
1. Perform Crankcase Disassembly page 3.67.
2. Note timing marks on balance shaft and crankshaft
drive gears. Shafts must be properly timed upon
assembly.
3. Carefully rotate the balance shaft
from the crankcase.
4. Inspect the balance shaft gear teeth for damage.
3
q
and remove it
3.69