Siemens SIMATIC IFP2200 INOX MT ETH Compact Operating Instructions page 24

Installing and connecting the device
3.3 Mounting the device
6. Tighten the setscrews of the opposite (diagonal) corner mounting clips:
– Torque wrench, tightening torque 1.3 Nm
– Order of action: ③-④-⑤-⑥
7. Continue in the same way with the top and bottom row from the outside in and on the
opposite (diagonal) end.
8. Continue in the same way with the left and right row from the outside in and on the
opposite (diagonal) end until all mounting clips are installed.
9. Check to make sure that the stainless steel front rests against the installation location on all
sides and that the mounting seal is pressed down all around.
10. Tighten all mounting clips once again with the torque wrench and a tightening torque of
1.3 Nm.
Removal
Proceed in the reverse order for the removal. Dispose of the used mounting seal.
See also
Accessories (Page 9)
24
Compact Operating Instructions, 07/2021, A5E42185570-AD
IFP2200 INOX MT ETH