Remove Clutch Gear Shafts - Husqvarna WS440HF Workshop Manual

10.2
1
3
80
REPAIR INSTRUCTIONS
2
WS482
4
WS482

Remove Clutch Gear Shafts

WS482
First see: Disassemble Arm (p.
79)
WS 440 does not have the two Idler
gear shafts (Nr�1 in orientation
picture) because it doesn't have a gear
selector�
Orientation Picture of the shafts:
1� Clutch gear chafts
2� Center gear shaft
3� Idler gear chafts
1� Start by remove the bearings on
both idler gear shafts (nr�3) by
WS482
insert a bolt on the shaft as an
extender�
2� Use a universal bearing puller to
remove the bearings on idler gear
shafts (nr�3)�
3� Pull the center bearing (nr�2) off
with a universal bearing puller�
4� Remove the two clutch gear shafts
WS482
(nr�1) assembled with the bearing
with special Tool nr: 584 39 99-01�