Mount Saw Arm - Husqvarna WS440HF Workshop Manual

1
3
5
7
9
REPAIR INSTRUCTIONS
2
4
6
WS482
8
WS482
10
WS482

Mount Saw Arm

First see: Detach Arm/Housing (p.
77)
1� Inspect the plastic plugs�
2� Apply grease to the surface and
then insert a new X-ring�
3� Wipe off any grease from the
surface�
4� Insert the friction lining�
5� Remove hoses from the water
connector�
6� Loosen the two locking screws on
top of the connector�
WS482
7� Rotate the screws until the
excenters are in their lowest
position and the flat screw heads
are vertical�
8� Tighten the locking screws�
9� Apply grease to the outer surface
and insert a brand new X-ring�
10� Apply grease to the surface and
WS482
then insert a brand new X-ring�
WS482
10.2
95