Table of Contents
Advertisement
Hydraulic top clamps
2M roller table
Blade Deviation Detector & Calibration Procedure
Blade Deviation Detector
The top clamp device composed of two clamps is
installed on top of the front and rear vises before
executing bundle cutting.
Refer to Using Top Clamp for Bundle Cutting for
operating procedure on bundle cutting.
The optional 2M roller table supports the work material
and ensures the material be fed in smoothly.
Refer to Section 9 for further information on adjusting
the roller table.
This device detects blade deviation. If the blade deviates
beyond the preset range, the machine will stop
automatically. When this device is installed, the cutting
width will be reduced. The blade deviation detected value
and preset values are displayed on the HMI screen.
Before cutting, please make sure if the deviation value is
"Zero". If not, please calibrate the deviation detector before
proceeding to cutting.
4-21
Advertisement
Table of Contents
