Table of Contents
Advertisement
OPTIONAL ACCESSORIES
Vise pressure regulator
Pressure
gauge
Vibration damper
Cover
with vibration damper
without vibration damper
Chip conveyor
4-20
Pressure
adjusting
valve
The vibration damper can be assembled to the left saw arm. This
Nuts &
optional accessory is extremely useful in reducing the blade vibration
washers
produced under high-speed cutting. Especially for cutting small
materials on bandsaws of large width capacity, the vibration damper
can reduce blade vibration, increase cutting rate, and enable smooth
cut-off surfaces.
When cutting round and square material with C-420NC, use of vibration
damper will limit the capacity to 15.6" (398mm). When cutting
rectangular material with C-420NC, use of vibration damper will limit
the HxW capacity to 15.6" (398mm) x 16.5" (420mm).
Therefore, when intending to cut at full capacity, vibration damper
needs to be taken off. Please follow below steps to take off the vibration
damper.
1.
Loosen the nuts.
2.
Remove the cover, nuts, washers, and vibration damper.
3.
Tighten the nuts and washers back.
Chip conveyor is a spiral device to bring chips out during cutting.
As a regular maintenance, remove the chip conveyor and clean all chip
deposits inside.
This adjustment valve is used to control vise pressure.
Adjust vise pressure based on the material of your workpiece.
When cutting pipes or soft materials, reduce vise pressure to
prevent exerted pressure from damaging the workpiece shape
or exterior.
Do not adjust vise pressure at any time during cutting.
Vise pressure should never be lower than 8 kg/cm
2
.
Advertisement
Table of Contents
