Table of Contents
Advertisement
PRECAUTIONS
When an abnormality occurs in the machine during operation, you can do it yourself safely. If you
have to stop machine motion immediately for parts exchanging, you should do so according to the
following procedures:
Press HYDRAULIC MOTOR OFF button or EMERGENCY STOP button.
Open the electrical enclosure door.
Turn off breaker.
BEFORE ANY ADJUSTMENT OR MAINTENANCE OF THE MACHINE, PLEASE MAKE SURE TO
TURN OFF THE MACHINE AND DISCONNECT THE POWER SUPPLY.
GENERAL TROUBLES AND SOLUTIONS
DISCONNECT POWER CORD TO MOTOR BEFORE ATTEMPTING ANY REPAIR OR INSPECTION.
TROUBLE
Excessive belt tension
Excessive head
Motor stalls
pressure
Excessive blade speed
Improper blade
selection
Dull blade
Guide rollers not
adjusted properly
Cannot make
Rear vise jaw not
square cut
adjusted properly
Excessive head
pressure
Dull blade
Increased cutting
Insufficient head
time
pressure
Reduce blade speed
Motor running in wrong
direction
Blade teeth pointing in
wrong direction
Will not cut
Hardened material
9-2
PROBABLE CAUSE
SUGGESTED REMEDY
Adjust belt tension so that belt does not slip on drive
pulley while cutting ( 1/2" Min. deflection of belt under
moderate pressure.)
Reduce head pressure. Refer to Operating Instructions
"Adjusting Feed".
Refer to Operating Instructions "Speed Selection".
Refer to Operating Instructions "Blade Selection".
Replace blade.
Refer to Adjustments.
Set fixed vise jaw 90 to blade.
Reduce head pressure. Refer to operating instructions
"Adjusting Feed."
Replace blade
Increase head pressure. Refer to Operating Instructions
"Adjusting Feed."
Refer to Operating Instructions "Speed Selection."
Reverse rotation of motor. (Motor rotation C.C.W.
pulley end.)
Remove blade, turn blade inside out.
Re-install blade. (Teeth must point in direction of
travel. )
Use special alloy blades. (Consult your
industrial distributor for recommendation on type of
blade required.)
Advertisement
Table of Contents
